Samplers AVRORA-NEFT PSUR, PSR, PSPRP, PSPR-1, etc.

Sectional samplers
The samplers are designed to take integral analytical samples from certain levels of a tank with a gravity drain. This is a stationary metal installation for vertical tanks, which allows you to obtain the actual composition of the product at any level of the tank.
MODELS: PSUR, PSR

Stationary sampler
Organ-type samplers are designed for the selection of mixed and discrete samples of oil, petroleum products, edible oils (for example, sunflower) and other liquids with normal and elevated pressure. Their use is permissible in tanks without a pontoon and floating roof, and with it, for which there is a modification of the PSPR (P).
MODELS: PSPR, PSPRP, PSRP

Sampler for sampling from pipelines
Samplers are used for layer-by-layer sampling of oil and petroleum products from pipelines at a pressure of up to 6.3 MPa. It is intended for use at operational and commercial oil metering units and during oil quality control. The equipment meets the requirements set out in GOST 2517-85.
MODELS: PSPR-1

Portable samplers
Portable samplers are designed for sampling oil and petroleum products along the entire height of the tank, as well as bottom sediments (samples). The design allows the device to work properly both at normal and at elevated pressure. Installation is carried out inside the tank, which can be new or after repair / reconstruction.
MODELS: PO-1, PO-2

Tank samplers reduced
Spot sampling from various product levels in the tank is carried out using tank-mounted reduced samplers. Depending on the required fence level, the appropriate crane is selected. The sample taken with the sampler completely coincides in chemical composition with the product located on each of the three layers of the tank.
MODELS: PRSt, PRSpt

Earthing samplers
Samplers are used for sampling petroleum products from tanks, tankers at gas stations or oil depots. The sample is taken from any point vertically when the tank is fully filled.
MODELS: PPMN

Standard samplers
The Standard oil and petroleum product samplers work properly in a wide range of operating pressure — from 0.2 to 6.3 MPa, with an acceptable bypass line diameter of 50 mm.
MODELS: Standard-R, Standard-A, Standard-AL

Slot type sampler
The slot-type sampler is a complex of technical means for manual and automatic sampling of oil and petroleum products. To obtain a valid analysis result, it is necessary to preserve the initial conditions at the selection point. The design of the device allows you not to change the necessary parameters: the pressure at the sampling point and the gas saturation of the well.

Tube type samplers
The tube-type sampling device is used to take samples of oil and petroleum products from pipelines with a nominal diameter from 80 to 400 mm and a pressure from 0.2 to 6.3 Mpa.

Measuring bucket
The measuring bucket is used to take samples of petroleum products from tanks through a special measuring hatch provided for this purpose.
MODELS: VZ

DOCUMENTATION

• PSUR. Technical specifications
• PSRP. Technical specifications
• PSRP1. Technical specifications
• PSHCH. Technical specifications
• PRST. Technical specifications
• PPMN. Technical specifications
• PO1/2. Technical specifications

Questionnaire

Catalog